JATEC supports the development of additive manufacturing for Ukraine’s unmanned systems

The NATO-Ukraine Joint Analysis, Training and Education Centre (JATEC) is implementing a project to develop additive manufacturing systems for unmanned aerial vehicles (UAVs).
The project aims to introduce innovations that support the defence of Ukraine and NATO member countries.
Rapid production of essential drone components, along with the repair and modernisation of existing systems, plays an important role in maintaining their effectiveness on the battlefield.
Additive manufacturing for UAV production, repair, and modernisation
Additive manufacturing is a process in which a part is built layer by layer from a digital model, rather than by removing excess material.
One of the project’s practical stages was a seminar attended by representatives of unmanned systems units of the Defence Forces of Ukraine, additive manufacturing experts, and representatives of NATO member countries.
Participants focused on three areas:
- using additive manufacturing technologies for the rapid repair and modernisation of UAVs;
- supplying units with essential components;
- developing tactical logistics.
All three areas contribute to maintaining unmanned systems capabilities within the military.
Training additive manufacturing specialists
An important aspect of the project is building an expert community and training specialists who can turn technological capabilities into practical solutions for the military.
Importantly, the project translates Ukraine’s battlefield experience into solutions that strengthen defence capabilities through cooperation with NATO partners.
The Ministry of Defence of Ukraine previously reported that JATEC had presented two AI-based solutions. The first predicts enemy drone attacks, while the second helps plan Ukraine’s own artillery operations.
